control limits

英 [kənˈtrəʊl ˈlɪmɪts] 美 [kənˈtroʊl ˈlɪmɪts]

网络  控制范围; 控制界限; 控制限; 管制界限; 控制极限

机械



双语例句

  1. In addition, Mr Davis said buying-power control limits had been removed in some cases, because they sometimes made trading desks less efficient when a lot of customers were placing orders.
    另外,戴维斯表示,买入权控制上限有时会被取消,因为当大量客户下单时,这些限制有时会降低交易席位的效率。
  2. Manufacturers and importers may need to review their quality control limits again in order to ensure the best protection of their brand reputation.
    制造商和进口商需要重新审查其产品质量控制限值,以确保符合相关规定,保护品牌声誉。
  3. A new quality control approach to the small batch production, which used dynamic control limits based on t-distribution, was presented, and the simple and convenient algorithm was also addressed.
    接着考虑到并行工程中产品的可制造性设计要求,针对目前制造企业普遍采用的多品种小批量生产模式,提出了一种对应的产品制造质量管理与控制系统。
  4. A.Any one point outside the Upper or Lower Control Limits.
    任一点超出上限或下限控制。
  5. Thousands of people understand that investigation of ups and downs within the control limits creates trouble increases variation causes severe loss.
    有数以千计的人明白在管制界限内调查起伏状况会造成麻烦、增加变异、导致严重的损失。
  6. Major parts of the researching process, the formula for the optical control limits and the application condi.
    最小的控制界优化数学模型,最后给出主要研究过程、最优控制下限的数学表达式及其适用条件。
  7. If the adaptation values reach the control limits in opposite directions, interchanged oxygen sensors will be detected.
    如果自适应值在相反方向上达到控制极限,则将检测到氧传感器被互换。
  8. Plotting specification limits instead of control limits.
    策划规范的限制代替了控制的界限。
  9. But the defects in IC fabrication tend to cluster and the Negative binomial distribution or Neyman distribution should be used to describe the number of defects and calculate the control limits.
    在这种情况下,需要采用描述缺陷成团现象的负二项分布和黎曼分布构造控制图。
  10. The forewarning control limits and time series regression judgment model are built up based on the reliability series model in a non-repairable system and Shewhart control charts.
    研究结果:利用不可修复可靠性串联模型与休哈特控制图建立预警控制界限,建立时间序列回归判别模型。
  11. As an example, evaluation of process variation would determine if established equipment, facility, and process control limits were met.
    例如,工艺波动评价会决定设备、公用系统或工艺控制的实际值是否达到设定的限度。
  12. Optimization of quality characteristic control limits in rocket engine process
    发动机生产加工中质量控制界限的优化
  13. Average production length ( APL) is introduced as the criterion for measuring control scheme performance. A model is developed with sampling rate and maximum false alarm rate as inputs to determine the optimum subgroup size and control limits as measured by APL.
    本文以平均运行长度(APL)为衡量控制图有效性的标准,以抽样比例和最大可接受错误报警率为输入,通过建立模型的方法,确定最佳的样本容量和控制线参数。
  14. The quality loss function was led into and the model of the process control limits was discussed. and basic methods of the solution was provided.
    在博采休哈特学派与田口学派之从长的基础上,企图引入质量损失函数,探讨工序质量最优控制界限的模型,并给出求解的基本思路。
  15. Research on Dynamic Quality Control Limits and Its Convenient Calculation Method under Small Batch Production Conditions
    基于小批量制造过程的动态质量控制限及其简便计算方法
  16. This paper discussed about the basic requirements of funding process coefficients, determinating control chart type and control limits by using control chart method to control testing and calibration results in test and calibration laboratories. And then took some practical examples for it.
    论述了检测/校准实验室采用控制图技术控制检测/校准结果时建立过程参数、确定控制图类型和控制极限基本要求,并给出了应用实例。
  17. The Economic Design of the Control limits K
    自动检测中的经济设计问题
  18. This paper describes some basic problems that are meeted with the control limits, the basic function, the data collection, the structure of system and the practice of scheme etc, when iron and steel enterprises proceed the feasibility study of the energy center.
    本文阐述了在钢铁企业能源中心可行性研究时涉及的管理范围、基本功能、数据采集、系统配置和方案实施等基本问题。
  19. This thesis put forward the idea of using control chart method, which belongs to the Statistical Quality Control theory to monitor the model risk of VaR model, designs a RL2 control chart, calculates its control limits and discusses its control effect.
    本文提出利用统计质量控制理论中的控制图技术来实现对风险价值VaR的模型风险的预警、监控,设计了RL2控制图,计算了其控制限并论证了其控制效果。
  20. The host computer acquires the capacity data of battery and AC status from UUT through the network, and then compared it with the control limits thus to control the output status of the power box.
    主控机通过网络读取测试机的AC状态和电池电量与控制限值比较,进而控制电源箱的输出状态达到充放电测试的目的。
  21. When the observations can be fitted by an AR ( 2) model in time series models, the control limits of X|--s chart are modified.
    在过程测量值可以用AR(2)模型拟合时,本文修正了X&s控制图的控制界限。
  22. Optimization of Control Limits of Consecutive Conforming Run-Length Control Charts in 6 σ Quality Level
    6σ质量水平下的连续合格链长控制图及其控制界的优化
  23. The control limits of the influence factors are given.
    提出了影响因素的控制范围。
  24. Particle source is analyses, and then it introduces the application of C control chart, as well as its shortage, at last brings forward the method of using multiple regression analysis to set control limits for the particles.
    首先分析了半导体制造中颗粒污染的来源,然后介绍了用C控制图进行颗粒污染控制的方法及其不足,进而提出了用多元回归分析进行颗粒污染控制的方法及实施。
  25. After two and a half of regulation, steam flooding pilot test achieved good results, and formed a plan of steam flooding technology dynamic control limits of ultra-heavy oil for improving the steam swept volume and prevent steam breakthrough.
    经过两年半的调控,蒸汽驱先导试验取得了较好的效果,并形成了一套提高蒸汽波及体积和防止蒸汽突破的超稠油蒸汽驱动态调控技术界限。
  26. In the process of online monitoring, system platform on one hand, reads real-time sampling data, on the other hand, calls on-line monitoring procedure for processing real-time data to compare the statistics generated with the corresponding control limits in the database and maps the real-time curves.
    在线监测过程中,系统平台一方面读取实时采样的数据,另一方面调用在线监测程序对实时数据进行处理,将生成统计量与数据库中相应的控制限进行比较并且实时的绘制在曲线图中。
  27. The use of a control chart requires that the engineer or analyst select a sample size, a sampling frequency or interval between samples, and the control limits for chart.
    要使用控制图就要求工程师或分析员为控制图选择样本容量、抽样频率(抽样时间隔或抽样区间)和控制限。
  28. On the basis of analysis quality control methods used in non-normal process, we propose weight variation method as a tool to split distribution to construct asymmetry control limits.
    本文在对非正态分布过程控制方法分析的基础上,引入赋权方差法作为一种分离分布的技术来构造不对称的控制线。
  29. Based on sample auto-correlated function, the control limits are modified to be used in all stationary processes.
    另外,基于样本自相关函数,改进了常规控制图的控制界限,使之适用于所有的平稳自相关过程。